Remote Processing CAMBASIC - Manual (Page 181)

CON FIG C ommands - 8
CONFIG DISPLAY
Statement
SYNTA X: CONFIG DISPLAY address,type, cursor
PURPOSE: To install a driver for a display
REMARK S: CAM BASIC suppor ts eight vacuum fluore scent (DP ser ies) and liquid crystal (LC D) displays.
When the CON FIG D ISPLAY statement is executed, a driver is installed that tells CAM BASIC the
I/O address, type and cursor.
The address is the address of the output port at which the display is located. See your hardware
manual for mor e information.
The type parameter is determined by the display type, as shown in the table below:
0 DP-1x16 VF, 1 line, 16 char/ line
1 DP-2x20 VF, 2 line, 20 char/ line
2 DP-2x40 VF, 2 line, 40 char/ line
3 DP-4x20 VF, 4 line, 20 char/ line
4 LCD -2x20 LCD , 2 line, 20 char/line
5 LCD -2x40 LCD , 2 line, 40 char/line
6 LCD -4x20 LCD , 4 line, 20 char/line
7 LCD -4x40 LCD , 4 line, 40 char/line
8 L C D LCD , G raphic
The cursor parameter sets the cursor type. This may not be valid, depending upon the display type.
For D P series displays:
0 cursor not displayed (all models)
2 cursor displayed, 2x40, 4x20
For L CD ch aracter displays:
0 cursor not displayed
1 blinking cursor
2 steady cursor
RELATED: DISPLAY