Start count – Remote Processing CAMBASIC User Manual
Page 154
Comm ands - 121
START COUNT
Tasking Statement
SYNTAX:
START COUNT n [, n 1] [, n m]
PURPOSE:
To activate a software counter task that was previously defined.
REMARK S:
Once on e or m ore cou nters hav e been defin ed by the C ONF IG CO UN T statem ent, the counter is
activated by the START CO UNT statement. Until that time no counts will be accumulated.
The range of n is 0 to 7, which is the counter number.
See the Multitasking Chapter for more information.
RELATED:
CLEAR COUNT, ON COUNT, CONFIG COUNT, STOP COUNT, RESUME COUNT
EXAMPLE:
10 CONFIG COUNT 0,1,0
20 START COUNT 0
ERROR:
< Data negative> – for n
< Data out of range> – if n > 7