Remote Processing CAMBASIC - Manual (Page 158)

Comm ands - 125
STOP COUNT
Tasking Statement
SYNTAX: STOP COUNT n [, n 1] [, n n]
PURPOSE: To deactivate a software counter task that was previously active.
REMARK S: This statement is used to suspend a counter that has previously been started. The accum ulated count
is not changed.
You can restart the counter at the same point by executing START COUNT.
The range of n is 0 to 7.
See the Multitasking Chapter for more information.
RELATED: C L E A R C O U N T , C O N F IG C O U N T , O N C O U N T , R E SU M E C O U N T , S T A R T C O U N T
EXAMPLE: 10 STOP COUNT 0,1
ERROR: < Data negative> – for n
< Data out of range> – if n > 7