Remote Processing CAMBASIC - Manual (Page 176)

CON FIG C ommands - 3
within one ch aracter time after the last char acter is sen t.
0 = RS-232 (de fault)
1 = RS-422 (transmitter always on)
2 = RS-485
RPC-2350 NOTE: The CAM BASIC statement BIT 128,4, 0 may need to be executed before you
will receive any characters. This command enables the CTS line to the sender.
RELATED: none
EXAMPLE: 10 CONFIG BAUD 1,7,5,0
This sets CO M1 for the default values.
ERROR: < Data negative > – all parameters
< Data out of range > – if illegal baud, mode or parity parameter.