Precision Digital PD6830 - Manual (Page 92)

PD6830 Pulse Input Rate/Totalizer Instruction Manual
92
Resetting the Total (RESET TOTAL?)
If manual Total Reset is enabled in the Program menu, the total may be reset by
pressing the Reset button and using the Enter button to confirm the reset.
Additionally if programmed for manual reset, the total may be reset using a normally
open pushbutton connected across the terminals RST and COM.
Note:
The total is cleared immediately when Enter button is pressed. Totalization will
then continue, even if the Enter button or external reset button continues to be held
down/triggered.
Resetting the Grand Total (RESET GrTOT?)
If manual Grand Total Reset is enabled in the Program menu, the grand total may be
reset using the Reset button.
To reset the grand total, display the grand total by pressing the Up/Display button.
While grand total is being displayed, press the Reset button. Confirm the reset with
the Enter button.
Resetting Max/Min Readings (RESET MAXIMUM, MINIMUM)
The maximum and minimum readings may be reset by pressing the Reset button
while displaying either the maximum or minimum. The display will show RESET to
verify the reset of maximum or minimum value.
The maximum and minimum must be reset individually.
Reset Meter to Factory Defaults
Reset to factory defaults will restore most meter parameters to their factory default
setting.
When the parameters have been changed in a way that is difficult to determine
what’s happening, it might be better to start the setup process from the factory
defaults.
Factory default reset does not change the saved backup restore settings, override
passwords, or edit parameters locked by a permanent non-resettable grand total.
See Non-Resettable Grand Total, as described on page 75.
Instructions to load factory defaults can be found in the Backup & Restore (BACKUP)
menu on page 84.