Precision Digital PD6830 - Manual (Page 29)

PD6830 Pulse Input Rate/Totalizer Instruction Manual
29
Menu Button
 Hold the Menu SafeTouch® button when in power save mode (display will
show ) to awaken SafeTouch® buttons.
 Press the Menu button to enter Programming Mode.
 Press the Menu button during Programming Mode to return to the previous
menu selections.
 Hold the Menu button for 1.5 seconds at any time to exit Programming Mode
and return to Run Mode.
 Press and hold the Menu button for 3 seconds to access the Advanced Fea-
tures
of the meter.
Right / Reset Button
 Press the Right arrow button to move to the next digit or decimal position
during programming.
 Press Right to go backward through most selection menus.
 Press Reset to reset the total, or values displayed in the bottom display
(grand total, max, or min). Press Enter after Reset to confirm the reset.
Up / Display Button
 Press Display when in Run mode to display the grand total, again to display
the maximum, and again to display the minimum reading since last reset.
These displays will time out in 12 seconds, or press Display until total is dis-
played in the lower display. Press Enter to lock this display, and disable the
12 second time out.
 Press the Up arrow button to scroll forward through the menus, decimal point,
or to increment the value of a digit.
Enter
Button
 Press the Enter button to access a menu or to accept a setting.
 Press Enter to lock the grand total, maximum, or minimum value on the lower
display, and disable the 12 second time out.
 Press Enter while the grand total, max, or min reading is locked on the lower
display to return to run mode.
 Press Enter to acknowledge alarm (if enabled).
 Press Enter to lock display of grand total, Max or Min readings (disables 10
second timeout).