Epson EQUITY 386/33 PLUS - Manual (Page 89)

Chapter 5
Installing and Removing Drives
The instructions in this chapter describe how to install and
remove optional Epson drives in your computer. You can use
these instructions to install a variety of devices, including
diskette drives, hard disk drives, and tape drives. Although
your drive may look a bit different from the one illustrated
here, you install it the same way.
If you are installing or removing a non-Epson drive, some of
the steps in this chapter may not apply; see the documentation
that came with your drive for more information.
Before you perform any of the procedures described below,
follow the steps in Chapter 3 to remove the computer’s cover
and subassembly.
When you complete your drive installation or removal, follow
the instructions in Chapter 3 to replace the subassembly and
cover. Then see “Post-installation Setup Procedures” at the end
of Chapter 4 for information about updating the SETUP
program with your new drive configuration.
Caution
Installing or removing a disk drive is a complicated
procedure, so you may want to ask your dealer to do it for
you. If you decide to do it yourself, follow all the
instructions in this chapter carefully, or you could damage
your system.
installing and Removing Drives 5-1