Epson EQUITY 386/33 PLUS - Manual (Page 87)

Using the CORFIX Program
To configure your computer for use with the RampagePlus
286+ memory card, you need to run CORFIX, a utility program
on your Reference diskette; and then run SMART, the
RampagePlus 286+ setup program.
Follow these steps to run CORFIX:
1. If you copied the CORFIX.EXE file to your hard disk, log onto
the
directory where it is stored. If you did
not
copy the file,
insert the Reference disk in drive A. Then type
A
: and press
to log onto that drive.
2. Type
CORFIX
and press You see the following
message:
The program will configure the system to
work
with the SMART utility when
installing the RampagePlus 286.
Smart can only be executed immediately
after this configuration program.
Continue? (Y/N)
3. To run the program, press To exit without running the
program, press If you press you see
the
operating
system prompt and the following message:
Configuration completed. The SMART
installation utility may now be used.
Now you can run the SMART setup program as described in
your RampagePlus 286+ manual.
installing and Removing Options 4-27