Epson EQUITY 386/33 PLUS - Manual (Page 86)

Removing a Math Coprocessor
If you need to remove a math coprocessor from your computer,
contact your dealer for assistance. You need a special extracting
tool to remove the coprocessor without damaging it. Do not
attempt to remove it without this tool; you can easily damage it.
Follow the steps in Chapter 3 to remove the computer’s cover
and subassembly. Then remove the coprocessor with the tool
and replace the subassembly and the cover.
After you remove the coprocessor, run the SETUP program to
configure your system for use without it. See Chapter 2 of the
Setup Guide for instructions.
Post-installation Setup for Memory Curds
After you install an optional memory card, you need to
configure your computer to use it. Follow these guidelines:
Run the SETUP program to reset your computer’s
configuration to include the memory on your memory card.
See Chapter 2 of the Setup Guide for instructions.
Use the setup program that comes with your memory card
to configure the computer for use with your particular card.
See your memory card manual for instructions.
If you installed the RampagePlus® 286+ memory card,
follow the instructions in “Using the CORFIX Program,”
below, before you install the RampagePlus software.
Also see “Post-installation Setup,” below, for more information
on setting up your computer for use with an option card.
4-26 Installing and Removing Options