Epson EL 486UC User Manual
Epson
Table of contents
Document Outline
- FRONT COVER
- CONTENTS
- INTRODUCTION
- CHAP 1-SETTING UP YOUR SYSTEM
- CHAP 2-RUNNING THE SETUP PROGRAM
- CHAP 3-USING YOUR COMPUTER
- CHAP 4-INSTALLING AND REMOVING OPTIONS
- Removing the Cover
- Replacing the Cover
- Locating the Internal Components
- Changing the Jumper Settings
- Installing Memory Modules (SIMMs)
- Installing an Option Card
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Adding Video Memory
- Installing External Cache
- Upgrading the Microprocessor
- Post-installation Procedures
- CHAP 5-INSTALLING AND REMOVING DRIVES
- lnstalling a Hard Disk Drive in the lnternaI Drive Bay
- Removing a Hard Disk Drive From the Internal Drive Bay
- Installing a Drive in the Upper External Drive Bay
- Removing a Drive from the Upper Drive Bay
- Reconnecting the Drive and Power Cables to the Diskette Drive in the Lower Drive Bay
- Post-installation Procedures
- CHAP 6-TROUBLESHOOTING
- Identifying Your System
- The Computer Will Not Start
- The Computer Does Not Respond
- Keyboard Problems
- Monitor Problems
- Diskette Problems
- Diskette Drive Problems
- Hard Disk Drive Problems
- Password Rob/ems
- Software Problems
- Printer Problems
- Option Card Problems
- Memory Module Problems
- Mouse Problems
- Controller Problems
- Extrenal Cache Problems
- APPENDIX A-SPECIFICATIONS
- CPU and Memory
- Controllers
- lnterfaces
- Mass storage
- Keyboard
- SETUP Program
- Physical Characteristics
- Power Supply
- Option Slot Power Limits
- Environmental Requirements
- Video Resolutions and Colors
- Tested Operating Environments
- Options Available from EPSON
- Hard Disk Drive Types
- Drive Option Information
- Connector Pin Assignments
- DMA Assignments
- Hardware Interrupts
- System Memory Map
- System l/O Address Map
- INDEX