Entering keyboard commands – Epson EQUITY 386/33 PLUS User Manual

Page 36

Entering Keyboard Commands

You can change the processor speed by entering one of the

commands shown in the following table.

Speed setting commands

Numeric keypad commands

Speed setting

33 MHz

To enter these commands, hold down the [key and the

key simultaneously and then press the

key.

Use the

key on the numeric keypad.

Note

You can use the commands listed above while you are

running a program. However, if the program uses one of the

same commands for another function, you cannot use it to

change the processor speed. For example, if you are running

a program that uses the

command to move

the cursor, you cannot enter

to change the

processor speed to slow. Another alternative is to use the

ESPEED program, described below.

The speed setting remains in effect until you press the RESET

button or turn off the computer, or until you change it again

using the SETUP program, another keyboard command, or the

ESPEED program.

2-4

Enhancing System Operations