KACO XP10U-H4 - Manual (Page 49)

M a i n t e n a n c e / T r o u b l e s h o o t i n g
Installation Instructions blueplanet XP10U H4 / H6 and XP10U H4 / H6 PSD Page 49
Status Display Explanation Action
FS 101
to
106 Plausibility error
temperature,
effi
ciency, DC link,
AFI module, relay,
DC/DC converter
The unit has shut down because of
implausible internal measured values.  Notify KACO
Service
K
Table 6: Operating statuses and fault messages on the display
9.6 Replacing or cleaning the fan
The inverter is equipped with 1 axial fan. It is located in the upper right area of the housing.
Replace the fan:
– In case of heavy soiling
– If it is defective
Removing the fan
1. Ensure complete disconnection on the AC and DC
sides.
2. Wait until the fan is no longer turning.
3. Unscrew the Torx crews of the side housing cover
(Figure 15 on page 49).
4. Remove the side housing cover.
5. Unplug the fan plug.
6. Remove the side housing cover with the fan from the
housing.
7. Remove the fan from the side housing cover by pull-
ing it away from the cover.
» Install the replacement fan.
Figure 15: Removing the side housing cover
Installing the fan
↻ You have removed the defective fan.
 Replace the fan only with a fan recommended by
KACO. Ask KACO Service if necessary.
1. Insert the replacement fan into the fan holding
fi xture (see Figure 16 on page 49).
2. Plug in the fan plug.
3. Place the side housing cover on the unit.
4. Fasten the side housing cover to the unit with the
Torx screws.
5. Check that the fi ttings are secure and that the termi-
nals are well seated.
» The replacement fan is ready for operation.
Figure 16: Replacing the fan