KACO XP10U-H4 - Manual (Page 32)

C o n f i g u r a t i o n a n d O p e r a t i o n
Page 32 Installation Instructions blueplanet XP10U H4 / H6 and XP10U H4 / H6 PSD
Operating state LEDs Display Description
Feed-in operation Power fed into the grid
or measured values
The green “Operating” LED is illuminated.
The green “Feed-in” LED is illuminated.
The “Feed-in” icon appears on the desktop.
The inverter feeds into the grid.
Non-feed-in
operation
Status message The display shows the corresponding message.
Voltage Fault message The display shows the corresponding message.
The red “Fault” LED is illuminated.
8.1.2 Graphical display
The graphical display shows measured values and data and allows the confi guration of the inverter using a graphical
menu. In normal operation, the backlighting is switched off . As soon as you press one of the control keys, the backlight is
activated. If no key is pressed for an adjustable period of time, it switches off again. You can also permanently activate or
deactivate the backlighting. In sleep mode, the inverter deactivates the display regardless of the selected setting.
NOTICE
Depending on the tolerances of the measuring elements, the measured and displayed values
are not always the actual values. However, the measuring elements ensure maximum solar yield.
Due to these tolerances, the daily yields shown on the display may deviate from the values on the grid
operator’s feed-in meter by up to 15%.
After being switched on and after the initial start-up is complete, the inverter displays the start screen (the desktop). If
you are in the menu and do not touch the control keys for two minutes, the inverter returns to the desktop.
For information about initial start-up, see section 8.2 on page 34.
1
2
3
4
5
6
7
8
Figure 24: Desktop
Key
1 Current date 6 Status bar
2 Current power 7 Current time
3 Menu indicator 8 Feed-in indicator
4 Daily yield
5 Annual yield