KACO XP10U-H4 - Manual (Page 48)

M a i n t e n a n c e / T r o u b l e s h o o t i n g
Page 48 Installation Instructions blueplanet XP10U H4 / H6 and XP10U H4 / H6 PSD
Status Display Explanation Action
FS 81,
82,
83 Protect. shutdown
line volt.
L1 L2, L3 Overvoltage has been detected on
a conductor. An internal protective
mechanism has disconnected the
device to protect it against damage.  In case of repeated
occurrence:
Notify your
authorised
electrician.
E
FS 84 Protect. shutdown
undervolt. DC link A voltage deviation has been found
in the DC link. An internal protective
mechanism has disconnected the
device to protect it against damage.  In case of repeated
occurrence:
Notify your
authorised
electrician.
E
FS 85 Protect. shutdown
overvolt. DC link E
FS 86 Protect. shutdown
DC link asymmetry Overvoltage has been found in
the DC link. An internal protective
mechanism has disconnected the
device to protect it against damage.  In case of repeated
occurrence:
Notify your
authorised
electrician.
E
FS 87,
88,
89 Protection
shutdown
overcurrent L1, L2,
L3 A current that has been found
on a conductor is too high. An
internal protective mechanism has
disconnected the device to protect it
against damage.  In case of repeated
occurrence:
Notify your
authorised
electrician.
E
FS 93,
94 Buff er 1, buff er 2
self test error The control board is defective.  Notify authorised
electrician / KACO
Service
E/K
FS 95,
96 Relay 1, relay 2 self
test error The power section is defective.  Notify KACO
Service
K
FS 97 Protect. shutdown
overcurrent HW Too much power has been fed into
the grid. Complete disconnection of
the device.  Notify authorised
electrician / KACO
Service
E/K
FS 98 Protect. shutdown
HW gate driver An internal protective mechanism
has disconnected the device to
protect it against damage.
Complete disconnection of the
device.
 Notify authorised
electrician / KACO
Service
E/K
FS 99 Protect. shutdown:
HW buff er free An internal protective mechanism
has disconnected the device to
protect it against damage.
Complete disconnection of the
device.  Notify authorised
electrician / KACO
Service
E/K
FS 100 Protect. shutdown
HW overtemp. The device has been switched off
because the temperatures in the
housing were too high.  Check to make sure
that the fans are
working.
 Replace fan if
necessary.
B
E
Table 6: Operating statuses and fault messages on the display