KACO blueplanet 3.0 - 4.6 TL1 - Manual (Page 40)

EN EN
Configuration and Operation
Page 40 Operating Instructions for KACO blueplanet 3.0-4.6 TL1
Coun-
try-spec.
setting
menu
level
Display/
setting
Action in this menu/meaning
CH, GB, IT,
JO, UD
0 1 2 3 2 Q(U) 2-point
 Open the menu: Press the right arrow button or the
OK button.
0 1 2 3 3 Lock-in power
 Power range set as % of rated power, in which the
network support process is active.
0 1 2 3 3 Lock-out power
0 1 2 3 3 Time constant  Set the response speed of the control.
0 1 2 3 3 1.-4. Support point
 Specify the support points for voltage, power and
nature of the phase shift
DE, CH, BE,
CY,TW
0 1 2 3 1 Line error
Display of grid faults.
 To show the last 5 grid fault messages, select the
“Display” key.
CH, BE, CY,
DE-Nsp, DK
0 1 2 3 1
Protection param-
eters
Display of essential protection parameters.
 To show the protection parameters, select the “Dis-
play” key.
IT 0 1 2 3 1 SPI
 Provides the option of activating or confi guring the
specifi c "System Protection Interface" for Italian.
(Expansion module required!)
0 1 2 3 0
"Information"
menu
 Open the menu: Press the right arrow button or the
OK button.
0 1 2 3 1 Inv. type
Displays the type designation of the inverter.
If feed-in power is actively limited: display maximum
power in kW.
0 1 2 3 1 SW version Displays the installed software version.
0 1 2 3 1 Serial no. Displays the serial number of the inverter.
0 1 2 3 1 Display country
Displays the selected country setting.
Optional: Displays the grid type if a grid type has been
selected.
0 1 2 3 0
"Manufacturer"
menu
The display shows information about the unit manufac-
turer.
8.4 Monitor device
The inverter has an integrated web server. This makes it possible to monitor and record the operating state and yield
of your PV system.
You can display the recorded data using:
• The integrated LCD
• The integrated web server using an Internet-capable device connected to the Ethernet interface of the inverter
You can read the recorded data using a storage medium connected to the USB interface of the inverter, e.g. a USB
stick.