Yaskawa Sigma-5 User Manual: Operation of Digital Operator - Manual (Page 143)

4
Parameter Copy Mode
4.2 Operations
4-13
(2) Notes on Deleting Parameters Function
• If an empty block (“
∗∗∗∗
”) is selected and the deletion is executed, the message
“No Data” is displayed and the deletion will not be executed. Press the Key to
return to the parameter block selection display.
• If the digital operator is disconnected from the SERVOPACK during operation, the
selected parameter block becomes an empty block (“
∗∗∗∗
”).
• During deleting operation, the executing process is displayed sequentially as
shown below. The deleting operation takes about 2 seconds.
6
When the selected parameter block is
deleted, “Completed” is displayed.
7
After “Completed” is displayed, the
parameter block selection display
appears. “
∗∗∗∗
” is displayed for the
deleted block as an empty block.
8
Press the Key.
The display returns to the parameter copy
mode menu display.
(cont’d)
Step Display after Operation Keys Operation
0 0 : S G D V
− R 7 0
B B
− L I S T −
C o m p l e t e d
0 0 :
∗ ∗ ∗ ∗
0 1 : ∗ ∗ ∗ ∗
0 2 :
∗ ∗ ∗ ∗
0 3 :
∗ ∗ ∗ ∗
B B
− L I S T −
1 : S E R V O → O P
2 : O P
→ S E R V O
3 : V E R I F Y
4 : L I S T
B B − C O P Y −
While deleting the selected parameter block
Operation completed
0 0 : S G D V – R 7 0
D e l e t i n g
P a r a m e t e r s . .
B B – L I S T –
0 0 : S G D V – R 7 0
C o m p l e t e d
B B – L I S T –