Yaskawa Sigma-5 User Manual: Operation of Digital Operator - Manual (Page 139)

4
Parameter Copy Mode
4.2 Operations
4-9
4.2.3 Verify Parameters (VERIFY)
The parameters of the selected block saved in the digital operator and those in the
SERVOPACK are verified, and the result is displayed.
(1) Operating Procedure
Step Display after Operation Keys Operation
1
Open the parameter copy mode menu
display, and select “VERIFY” using the
or Key.
The blinking menu is one that is being
selected.
2
Press the Key.
The display changes to the parameter
block selection display.
3
Press the or Key to select
a parameter block (00 to 06) of the digi-
tal operator that is to be compared with
the SERVOPACK parameters.
4
Press the Key.
The display changes to the execution dis-
play.
5
Press the Key to start verifying
parameters.
Note: Not to execute verifying, press the
Key. The display returns to
the parameter block selection dis-
play.
1 : S E R V O
→ O P
2 : O P
→ S E R V O
3 : V E R I F Y
4 : L I S T
B B
− C O P Y −
0 0 : S G D V
− R 7 0
0 1 :
∗ ∗ ∗ ∗
0 2 : ∗ ∗ ∗ ∗
0 3 : ∗ ∗ ∗ ∗
B B
− V E R I F Y −
0 0 : S G D V
− R 7 0
0 1 : ∗ ∗ ∗ ∗
0 2 :
∗ ∗ ∗ ∗
0 3 :
∗ ∗ ∗ ∗
B B − V E R I F Y −
0 0 : S G D V
− R 7 0
S t a r t : [ R E A D ]
R e t u r n : [ M O D E ]
B B − V E R I F Y −
0 0 : S G D V − R 7 0
R e a d i n g
P a r a m e t e r s . .
< < O P > >
B B
− O P → S E R V O −