Yaskawa Sigma-5 User Manual: Operation of Digital Operator - Manual (Page 142)

4 Parameter Copy Mode
4.2.4 Parameter Block List Display (LIST)
4-12
4.2.4 Parameter Block List Display (LIST)
The statuses of one of seven parameter blocks in the storage area of digital operator
are displayed in a list, and unnecessary parameter blocks can be deleted.
(1) Operating Procedure
Step Display after Operation Keys Operation
1
Open the parameter copy mode menu
display, and select “LIST” using the
or Key.
The blinking menu is one that is being
selected.
2
Press the Key.
The display changes to the parameter
block selection display.
3
Press the or Key to select a
parameter block (00 to 06) of the digital
operator that is to be deleted.
4
Press the Key.
The display is switched to the deletion
execution display.
5
Press the Key to start deleting
the parameter block.
If power is supplied to the motor and
RUN is displayed, “Not Available” will
be displayed when the Key is
pressed. In this case, writing into SER-
VOPACK will be disabled.
1 : S E R V O
→ O P
2 : O P
→ S E R V O
3 : V E R I F Y
4 : L I S T
B B
− C O P Y −
0 0 : S G D V
− R 7 0
0 1 : ∗ ∗ ∗ ∗
0 2 :
∗ ∗ ∗ ∗
0 3 :
∗ ∗ ∗ ∗
B B − L I S T −
0 0 : S G D V
− R 7 0
0 1 :
∗ ∗ ∗ ∗
0 2 :
∗ ∗ ∗ ∗
0 3 :
∗ ∗ ∗ ∗
B B
− L I S T −
0 0 : S G D V
− R 7 0
F I L E D E L E T E
S t a r t : [ W R I T E ]
R e t u r n : [ M O D E ]
B B
− L I S T −
0 0 : S G D V
− R 7 0
D e l e t i n g
P a r a m e t e r s . .
B B
− L I S T −