SMA SMC 7000HV Installation - Manual (Page 20)

Mounting SMA Solar Technology AG
20 SMC70HV11-IA-IEN112970 Installation Manual
4. Screw the inverter onto the wall mounting bracket
on both sides using the screws (M6x8) provided.
For this purpose, only tighten the screws by hand.
5. Make sure that the inverter is securely seated.
6. Close the recessed grips with the fan grills
provided. To help you identify the sides, the
ventilation grids are marked "rechts/right" and
"links/left" on the inside.
The ventilation grids prevent dirt and insects from
entering the device and, if necessary, can be
reordered from SMA Solar Technology AG
(see section 13 "Contact" (page 85)).
Optional Theft Protection
To protect the inverter against theft, the rear
panel can be secured to the wall at the bottom
using 2 single-use bolts.
The other two holes are spares.