SMA SMC 7000HV Installation - Manual (Page 17)

SMA Solar Technology AG Mounting
Installation Manual SMC70HV11-IA-IEN112970 17
• The connection area must point downward.
• Never mount the device with a forward tilt.
• Never install the device with a sideways tilt.
• Do not mount horizontally.
• Mount at eye level to allow operating states to be read at all times.
• The ambient temperature should be below 40°C to ensure optimum operation.
• Do not expose the inverter to direct sunlight as this can cause excessive heating and thus
power reduction.
• In living areas, do not mount the unit on plasterboard walls or similar to avoid audible
vibrations. When in use, the inverter emits noises which may be perceived as a nuisance in a
living area.
• Observe the minimum clearances to walls, other
inverters or objects as shown in the diagram in
order to ensure sufficient heat dissipation and
sufficient space for removing the
Electronic Solar Switch.
Multiple inverters installed in areas with high ambient temperatures
There must be sufficient clearance between the individual inverters to ensure that the
cooling air of the adjacent inverter is not taken in.
If necessary, increase the clearance spaces and make sure there is enough fresh air supply
to ensure sufficient cooling of the inverters.
500 mm
300 mm
300 mm
50 mm
300 mm