SMA BEAM-BT-11 - Manual (Page 47)

SMA Solar Technology AG Settings
User Manual BeamBT11-BA-BEN112713 47
6.4 Adjusting the Display Deactivation
To save energy, the Sunny Beam can deactivate its display at night. Display deactivation takes place
after 1 minute by default. You can adjust the interval until display deactivation or set the display to
always remain switched on (setting "- - -").
If the interval until deactivation is greater than three minutes, the "Power today" chart appears after
three minutes of inactivity. The Sunny Beam displays the "Power today" chart until the display is
deactivated after the remaining specified interval has expired.
1. Select Settings > Display options > Display off after.
2. Set the interval.
Tip: The shorter the interval, the smaller the amount of energy consumed by the Sunny Beam.
3. To have the display always switched on, select - - -.
6.5 Adjusting the Repetition of the Signal Tone for Errors
The Sunny Beam uses a signal tone to inform you of errors. The signal tone is repeated until you press
the control button, however, not for more than 24 hours. Repetition takes place after 30 minutes by
default.
1. Select Settings > Alerts.
2. Select Signal tone every.
☑ Signal tone can be heard.
3. Set the desired interval after which the signal tone is to be repeated.
4. To disable the signal tone for errors, select - - - .