SMA BEAM-BT-11 - Manual (Page 44)

Settings SMA Solar Technology AG
44 BeamBT11-BA-BEN112713 User Manual
6.2.2 Setting the CO
2
Factor for Calculating the CO
2
Savings Factor
The CO
2
factor
*
for calculating the CO
2
saved depends on the fuel mix of the location of the plant.
You can find out how high the CO
2
factor of the location is by asking your electric utility company.
1. Select Settings > Display options > Factors of balance > CO2 / kWh.
2. Set the CO
2
factor.
6.2.3 Deactivating Overnight Shutdown for Wind Inverters
If you use wind inverters, you must deactivate the overnight shutdown of the Sunny Beam. As a result,
the Sunny Beam also queries data from the wind inverters at night. The overnight shutdown is
activated by default.
1. Select Settings > Data query > Overnight shutdown.
2. To deactivate overnight shutdown, deactivate the selection field "active".
Tip: To prevent electric discharge of the accumulator with deactivated overnight shutdown,
connect the Sunny Beam to the power supply at night (section 8.1.1).
6.2.4 Setting Plant Power in kWp
If no value for plant power in kWp was set when the Sunny Beam was commissioned, you can
subsequently set the value. The default setting is 0.00 kWp.
* For further information on the CO
2
factor, see section 1.