SMA BEAM-BT-11 - Manual (Page 25)

SMA Solar Technology AG Commissioning (Installer)
User Manual BeamBT11-BA-BEN112713 25
4.2 Notifying the Plant Owner of the new NetID and Plant
Password
Notify the plant owner of the following data:
• NetID of the plant
• Plant password for "User"
4.3 Installing the Sunny Beam
Installation location requirements:
☐ The installation location is indoors. Tip: Select a location that is exposed to sunlight if possible.
As a result, the Sunny Beam can optimally charge the accumulators using its integrated PV cell.
☐ Ambient temperature is always between 0°C and + 40°C.
☐ The installation location is protected against dust, moisture, and corrosive substances.
☐ The distance to devices that use the 2.4 GHz frequency band (e.g. WLAN devices,
microwaves) must be at least 1 m. As a result, you avoid reductions in the connection quality
and the data transmission speed.
☐ Connection quality is at least "good".
1. Set up the Sunny Beam at its intended installation location.
2. Check the connection quality (see section 6.13).