HEIDENHAIN TNC 620 (340 56x-02) Cycle programming - Manual (Page 70)

70 Fixed Cycles: Drilling
3.6 UNIVER
SAL DRILLING (Cy
c
le
203, DIN/ISO: G203, A
d
v
a
nced
Pr
ogr
amming F
e
at
ur
es Sof
tw
a
re
Option)
Please note while programming:
Program a positioning block for the starting point (hole
center) in the working plane with radius compensation R0.
The algebraic sign for the cycle parameter DEPTH
determines the working direction. If you program
DEPTH = 0, the cycle will not be executed.
Danger of collision!
Use the machine parameter displayDepthErr to define
whether, if a positive depth is entered, the TNC should
output an error message (on) or not (off).
Keep in mind that the TNC reverses the calculation for
pre-positioning when a positive depth is entered. This
means that the tool moves at rapid traverse in the tool axis
to setup clearance below the workpiece surface!