HEIDENHAIN TNC 620 (340 56x-02) Cycle programming - Manual (Page 395)

HEIDENHAIN TNC 620 395
16.1
0
MEA
S
URE RIDGE WIDTH (Cy
c
le 426, ISO: G426)
16.10 MEASURE RIDGE WIDTH
(Cycle 426, ISO: G426)
Cycle run
Touch Probe Cycle 426 measures the position and width of a ridge. If
you define the corresponding tolerance values in the cycle, the TNC
makes a nominal-to-actual value comparison and saves the deviation
value in system parameters.
1 The TNC positions the touch probe to the starting point 1 at rapid
traverse (value from FMAX column) following the positioning logic
(see “Executing touch probe cycles” on page 283). The TNC
calculates the touch points from the data in the cycle and the
safety clearance from the SET_UP column of the touch probe
table.
2 Then the touch probe moves to the entered measuring height and
probes the first touch point at the probing feed rate (column F). 1.
The first probing is always in the negative direction of the
programmed axis.
3 Then the touch probe moves at clearance height to the next
starting position and probes the second touch point.
4 Finally the TNC returns the touch probe to the clearance height and
saves the actual values and the deviation in the following Q
parameters:
Please note while programming:
X
Y
1
2
Parameter number Meaning
Q156 Actual value of measured length
Q157 Actual value of the centerline
Q166 Deviation of the measured length
Before a cycle definition you must have programmed a
tool call to define the touch probe axis.