HEIDENHAIN MSE 1000 - Manual (Page 90)

Commissioning and preparing to measure
Device setup
90 Operating Instructions
To view device setup options:
Click the «Setup» button.
Select a channel from the Tree.
Click the Device tab.
Device information and options are displayed for the selected channel.
Enable/disable error
monitoring Error monitoring checks for missing counts and other errors internal to a module.
Diagnostic screen information will be updated when error monitoring is enabled.
Disabling error monitoring is useful for increasing communication speed with EnDat
v2.2 encoders. Function reserves, errors, and warnings will not be monitored when
disabled.
To enable error monitoring:
Click the Error monitoring drop-down arrow.
Select «On» from the drop-down list.
Click the «OK» button.
A message verifying the action is displayed in the message area.
To disable error monitoring:
Click the Error monitoring drop-down arrow.
Select «Off» from the drop-down list.
Click the «OK» button.
A message verifying the action is displayed in the message area.
Select reference mark The reference mark setting is used with 1 V
PP
and TTL encoders. Reference marks are
used to re-establish datum positions after a power interruption.
The following table represents a partial list of HEIDENHAIN encoders. This table
describes the reference mark parameters that must set for the encoders. Most entries
can be found in the operating instructions for the encoder.
To select a reference mark:
Click the Reference mark drop-down arrow and select the required value.
Click the «OK» button.
A message verifying the action is displayed in the message area.