HEIDENHAIN MSE 1000 - Manual (Page 71)

Commissioning and preparing to measure
Network configuration
Operating Instructions 71
To use DHCP addressing:
Click the «Use DHCP Addressing» button.
A dialog box confirms that all modules have been set to DHCP addressing.
Cycle power for the entire module chain by turning the power off and then back on.
The Network LED on each module will flash five times per second while waiting for
DHCP to assign an IP address. The Network LED on each module will flash twice
per second when an address has been assigned.
Wait for the Network LED to flash twice per second on all modules.
Click the «OK» button in the dialog box.
MSEsetup performs a broadcast. Each modules Network LED will flash twice per
second until MSEsetup obtains a connection to the module. A dialog box confirms
the number of modules found.
Click the «OK» button in the dialog box to overwrite the configurable module
settings with a backup file or the «Cancel» button to skip overwriting the the
settings.
A message is displayed in the Connect screen message area when broadcasting is
finished.
Restore factory
defaults The Restore Factory Defaults option sets all of the modules in the module chain to the
factory default network settings.
Default network settings:
Module IP address Subnet Asynchronous
port Addressing
MSE 120x 172.31.46.2
MSE 11xx,
MSE 13xx,
MSE 1401,
MSE 1501 172.31.46.1
255.255.255.0 27300 DHCP