HEIDENHAIN MSE 1000 - Manual (Page 154)

Troubleshooting
Network troubleshooting
154 Operating Instructions
12.13.3 Recovering from IP address conflicts
Restoring modules to factory default settings and following the procedures described
here will help recover from communication problems if a subnet or netmask conflict is
discovered while troubleshooting.
Recovering with DHCP Recovering with DHCP IP address assignment:
Restore Factory Defaults. Refer to "Module Chain", page 70.
Restoring factory defaults will set all of the modules to Use DHCP addressing. The
modules will obtain an IP address and netmask from the DHCP router.
Configure the module chain with DHCP. Refer to "Configuring the module chain with
DHCP", page 73.
Recovering manually Recovering with static IP address assignment:
Restore Factory Defaults. Refer to "Module Chain", page 70.
Restoring factory defaults will set all of the modules to Use DHCP addressing.
The modules will timeout after 45 seconds waiting to obtain an IP address and
netmask.
Configure the module chain manually. Refer to "Configuring the module chain
manually", page 75.