HEIDENHAIN MSE 1000 - Manual (Page 152)

Troubleshooting
Network troubleshooting
152 Operating Instructions
Ipconfig Ipconfig can be used to show the IP address, netmask, and default gateway of all
network adapters.
To use IpConfig:
Open a command line program.
Enter "ipconfig" into the command line.
Press «Enter» on the keyboard.
Locate the network adapter that is being used to connect to the MSE 1000
modules and note the following information:
IP address
Subnet mask
If using DHCP:
Default gateway
Router IP address
12.13.2 Basic network troubleshooting
Verify power and
LED's Power cycle the workstation, router, and modules.
Verify that the Link LED on the workstation and router (if applicable) are lit.
Verify that the Network bus LED on the base module is lit.
Verify workstation NIC
settings Verify that the networking settings for the workstation NIC are configured correctly.
Refer to the documentation provided with the PC or NIC for instructions.
DHCP IP address assignment: Configure the NIC to Obtain an IP address
automatically.
Static IP address assignment: Manually configure the NIC IP address and netmask
to the required values. The subnet and netmask of the workstation and modules
must match.