HEIDENHAIN MSE 1000 - Manual (Page 116)

Installation and commissioning examples
Example using manual IP address assignment
116 Operating Instructions
10.2 Example using manual IP address assignment
The following information provides an example for how to install and commission an
MSE 1000 system with three modules and two encoders using manual IP address
assignment.
MSE 1000 modules with encoders:
MSE 1201 (ID 747501-01) AC 120 V power supply module
MSE 1184 (ID 747500-01) 1 V
PP
base module with one ST 128x length gauge
MSE 1314 (ID 747503-01) 4-channel EnDat module with one AT1217 length gauge
10.2.1 Mount the power supply and base modules
Mount power supply
module Mount the MSE 1201 (ID 747501-01) power supply module. Refer to "Mounting a
module", page 19.
Mount base module Mount the MSE 1184 (ID 747500-01) 1 V
PP
base module. Refer to "Mounting a
module", page 19.
Connect power supply
and base module Connect the power supply module and the base module. Refer to "Connecting
modules", page 20.
10.2.2 Connect the power cord
Connect the power
cord Connect the power cord to the MSE 1201 (ID 747501-01) power cord connector 4 .
Refer to "Connecting a power cord", page 27.
10.2.3 Connect the networking cable
A crossover cable may be required when connecting the workstation directly to
the base module. In this example a crossover cable is being used. Refer to the
documentation provided with the NIC to verify if a crossover cable is required.
Connect the base
module to the
workstation Connect one end of an RJ-45 network crossover cable to the RJ-45 connection
15 on the MSE 1184 (ID 747500-01) 1 V
PP
base module. Refer to "Connecting a
network cable", page 28.
Connect the other end of the network crossover cable to the workstation NIC.
Refer to the documentation provided with the workstation PC for instructions.