HEIDENHAIN ND 720 v.3 - Manual (Page 9)

9
Switch-On, Traversing the Reference Marks
ENT...CL
Turn on power (switch located on rear panel).
“REF” in status display starts blinking.
Confirm reference traverse mode. “REF”
remains on continuously. Decimal points start
blinking.
Cross over the reference marks in all axes in any
sequence. Each axis display becomes active
when its reference mark is crossed over.
0 è 1
ENT
Crossing over the reference marks stores the most recently defined
assignment of display values to axis slide positions for datum points 1
and 2 in nonvolatile memory.
Note that if you choose not to traverse the reference marks (by
clearing the dialog ENT ... CL with the CL key), this relationship will be
lost if the power is interrupted or when the unit is switched off.
Switch-On,
Traversing
the
Reference
Marks
If you wish to use multipoint axis error compensation you
must traverse the reference marks (see “Multipoint axis error
compensation”)!
Bateil1.pm6 07.11.2001, 10:36 9