HEIDENHAIN ND 720 v.3 - Manual (Page 65)

65
Output
S
tructure
of
C
ompensation-Value
Table
Compensation-value table Description:
.
X NR. 60 = ----------
X NR. 61 = ----------
X NR. 62 = ----------
X NR. 63 = ----------
* Final character (*);
Compensation-value table ND 760, Z axis
Compensation-value table Description:
* Starting character (*);
ND-760 MM Type of display unit; unit of measure (MM or IN);
AXIS = 2 Axis to be corrected, X = 0; Y = 1; Z = 2;
Z FCT. Z = 2 Axis causing the error, X = 0; Y = 1; Z = 2;
SPACING Z = 15 Spacing (range: 6 – 23)
DATUM Z = + 15.225 Datum point: +15.225 mm (value input)
Z NR. 00 = + 0.000 Compensation value 0 = 0.000 mm (compensation value 0 is always 0)
Z NR. 01 = - 0.030 Compensation values 1 – 10 are assigned values (value input)
Z NR. 02 = - 0.042 The axis is corrected from 15.225 mm to 342.905.
Z NR. 03 = - 0.008
Z NR. 04 = + 0.000
Z NR. 05 = + 0.009
Z NR. 06 = + 0.018
Z NR. 07 = + 0.025
Z NR. 08 = + 0.042
Z NR. 09 = + 0.051
Z NR. 10 = + 0.062
Z NR. 11 = ---------- Compensation values 11 – 63: no value entered (memory empty)
Z NR. 12 = ----------
.
Z NR. 63 = ----------
* Final character (*);
Bateil2.pm6 27.03.2002, 12:09 65