HEIDENHAIN ND 720 v.3 - Manual (Page 57)

57
b: Parameters:
The parameter setting can be edited by entering a value.
(e.g. LINEAR COR. 13,600 etc.)
P 3 1 . 1 S . P E R . = 1 2 8 0 0
6 characters 13 characters 3 ch. 13 characters 2 characters
P 3 8 . 1 L I N E A R C M P . = + 1 2 4 6 7
6 characters 13 characters 3 ch. 13 characters 2 characters
Parameter designation Parameter in plain language Sep. block Parameter value End
Left-aligned Right-aligned Right-aligned
Last line:
Each parameter list ends with the final character <*> (HEX: 0x2A)
*
The parameter text is sent in the language you have set and corresponds to the dialog text that is shown on the display unit.
However, the parameter value, not the text, is the decisive information when parameters are transferred to the display unit.
Output
Structure
of
Parameter
Lists
Bateil2.pm6 27.03.2002, 12:09 57