HEIDENHAIN ND 720 v.3 - Manual (Page 48)

48
Measured Value Output
Measured values can be output over the RS-232-C/V.24 interface. This
can be done with the following functions:
Probing with the KT Edge Finder
Contact input on X10
Pulse input on X10
CTRL B via the RS-232-C interface
Code letters with the measured value
Parameter P97 allows you to select a code letter to be output together
with the measured value when using Probe, Contact or Pulse. The
decimal number you enter in the parameter is the ASCII character
number in the ASCII table. If you enter 0, no code letter will be output.
The code letter enables you to recognize whether the measured value
was generated with CTRL B or with an external signal.
Axis designation for measured value output
Parameter P49 allows you to enter an axis designation for each
measured value that is output. The decimal number you enter in the
parameter is the ASCII character number in the ASCII table. If you enter
0, no axis designation will be output.
Example of measured value output:
Parameter settings:
P49.1 = 88 (“X”)
P49.2 = 89 (“Y”)
P49.3 = 90 (“Z”)
P51 = 0 (no line feeds)
P97 = 69 (“E”)
Output:
E (CR)(LF)
X=...(CR)(LF)
Y=...(CR)(LF)
Z=...(CR)(LF)
Measured
V
alue
O
utput
Bateil2.pm6 27.03.2002, 12:09 48