HEIDENHAIN ND 720 v.3 - Manual (Page 12)

12
Datum Setting
Z
Select the Z axis. “SET” lights.
The ❘<- status symbol starts blinking.
Touch the top of the workpiece with the
tool.
ENT
Z position is captured. “SET edge” is
shown briefly. SET starts blinking.
Retract the tool from the workpiece.
The ❘<- status symbol lights.
Enter the position value for the datum in
the Z axis.
0 ENT
After setting the datum, exit the probing
functions.
PROBE Z (appears only briefly)
SPEC
FCT
or
CL
1)
1)
1)
1)
1) only with ND 760
•
•
•
ENT
Y position is captured. “SET edge” is
shown briefly. SET starts blinking.
Retract tool from workpiece.
The ❘<- status symbol lights.
Enter position value for the datum
in the Y axis. Tool radius is automatically
compensated.
0 ENT
•
•
•
ENT
X position is captured. “SET edge” is
shown briefly. SET starts blinking.
Retract tool from workpiece.
The ❘<- status symbol lights.
Enter position value for the datum.
Tool radius is automatically
compensated.
0
Y
Select the Y axis. “SET” lights.
The ❘<- status symbol starts blinking.
ENT
Touch workpiece edge 2 with the tool.
PROBE Y (appears only briefly)
Touch workpiece edge 1 with the tool.
PROBE X
(appears only briefly)
Bateil1.pm6 07.11.2001, 10:36 12