HEIDENHAIN ND 720 v.3 - Manual (Page 54)

54
SEND COMP. X
Enter the code number 486153 and
confirm with ENT.
Input/Output of Parameter and
Compensation-Value Lists
To call the "data transfer" function:
Select the special functions.
SPEC
FCT
Select "parameter."
SPEC
FCT
or
Input/Output
of
Parameter
and
Compensation-Value
Lists
Select the dialog for entering
the code number.
PARAMETER
ENT
CODE
Data transfer function:
Proceed by pressing the ENT key.
TRANSFER
ENT
With the ENT key, the parameter list is
output over the RS-232-C/V.24 interface.
After output is completed, the display
unit returns to "TRANSFER" to send or
receive further lists. To proceed with the
data transfer menu, press the minus
key.
SEND PARAM.
ENT If req.
The display unit is ready to receive a
parameter list over the RS-232-C/V.24
interface. If no error occurs during the
reception of the parameter list, the
display unit is automatically reset and
restarted. To proceed with the data
transfer menu, press the minus key.
REC. PARAM.
If req.
ENT
With the ENT key, the compensation
value list for the X axis is output over the
RS-232-C/V.24 interface. After output is
completed, the display unit returns to
"TRANSFER" to send or receive further
lists. To proceed with the data transfer
menu, press the minus key.
If req.
Bateil2.pm6 27.03.2002, 12:09 54