HEIDENHAIN ND 720 v.3 - Manual (Page 45)

45
Multipoint
A
xis
Error
Compensation
AXIS X
Select the compensation value table
(e.g., for the Z axis), and delete the table.
DELETE Z
Confirm with ENT, or cancel with CL.
Conclude entry.
Deleting a compensation value table
Select the special functions.
PARAMETER
Select the dialog for entering the code
number.
CODE
Enter the code number 105296 and
confirm with ENT.
SPEC
FCT
Select the “parameter" function.
SPEC
FCT
or
28.024
Enter all further compensation points. If
you press the minus key, the unit will
show the number of the current
compensation point in the X display.
Direct selection of compensation
points: Press the minus key together
with the number (two-digit) of the
desired compensation point.
Conclude entry. or
Bateil2.pm6 27.03.2002, 12:09 45