HEIDENHAIN ND 720 v.3 - Manual (Page 17)

17
Datum Setting
X
Select the X axis (if not already selected).
The ->❘❘<- status symbol starts blinking.
Move edge finder toward workpiece
edge 1 until the indicator in the edge
finder lights. Back edge finder away
from the workpiece.
Move edge finder toward workpiece
edge 2 until the indicator in the edge
finder lights. “SET MIDPOINT“ is
shown briefly. “SET” begins to blink.
Back the edge finder away from the
workpiece. The ->❘❘<- symbol begins to
blink.
2 6
Set the position value for the midpoint
between the edges, e.g. 26.
Exit the probing functions.
ENT
SPEC
FCT
CL
or
1ST POS X
(appears only briefly)
2ND POS X (appears only briefly)
•
•
•
ENT
Confirm the “probe midpoint” function.
“SET” lights.
PROBE MIDP.
Bateil1.pm6 07.11.2001, 10:36 17