HEIDENHAIN TNC 370D - Manual (Page 90)

July 02 List of Markers and Words TNC 370 D 5–87
Word Function
D592 Nominal position for oriented spindle stop
D596 Max. feed rate from PLC
D604 Max. spindle speed from the PLC
D756 Preset speed from the PLC; programmed speed
W764 % factor for spindle override (PLC
® NC)
W766 % factor for feed-rate override (PLC
® NC)
D768
to
D956 Input values from MP4210.0 to MP4210.47
W960 to
W968 Input values from MP4220.0 to MP4220.4
W976 to
W988 Input values from MP4310.0 to MP4310.6
W1008 S code for minimum speed
W1010 Rotational speed increment for S code
W1022 Error status of the last called module
W1024 Axis releases, bit-coded (5/4/Z/Y/X)
W1026 Axes in position, bit-coded (5/4/Z/Y/X)
W1028 Axes in motion, bit-coded (5/4/Z/Y/X)
W1030 Traverse direction, bit-coded (5/4/Z/Y/X) 0 = positive; 1 = negative
W1032 Reference marks not yet traversed, bit-coded (4/Z/Y/X)
W1034 Positive software limit switch was traversed, bit-coded (4/Z/Y/X)
W1036 Negative software limit switch was traversed, bit-coded (4/Z/Y/X)
W1038 Preparing to open the position control loop, bit-coded (4/Z/Y/X)
W1040 Opening the control loop, bit-coded (4/Z/Y/X)
W1042 No monitoring, bit-coded (4/Z/Y/X)
W1044 Actual position capture, bit-coded (4/Z/Y/X)
W1046 Manual traversing with + direction button, bit-coded (4/Z/Y/X)
W1048 Manual traversing with – direction button, bit-coded (4/Z/Y/X)
W1050 Incremental jog positioning +, bit-coded (4/Z/Y/X)
W1052 Incremental jog positioning –, bit-coded (4/Z/Y/X)
W1054 Reference end position, bit-coded (4/Z/Y/X)
W1056 Lubrication pulse. Value from MP4060.x exceeded, bit-coded (4/Z/Y/X)
W1058 Reset the accumulated distance for lubrication, bit-coded (4/Z/Y/X)
W1060 Axis-specific feed rate enable (4/Z/Y/X)
W1062 Axis-specific inhibiting of handwheel pulses