List of markers and words, List of markers, 5list of markers and words – HEIDENHAIN TNC 370D User Manual
Page 84: 1 list of markers
July 02
List of Markers and Words
TNC 370 D
5–81
5
List of Markers and Words
5.1 List of Markers
Marker
S
R
Spindle
M4000 Spindle in position
NC
NC
M4001 Nominal speed command signal of the spindle not in the ramp
NC
NC
M4002 Nominal speed command signal of the spindle = zero
NC
NC
M4003 Nominal speed output analog or digital
NC
NC
M4004 Illegal rotational speed
NC
NC
M4005 Status display and nominal speed value output for M03
PLC PLC
M4006 Status display and nominal speed value output for M04
PLC PLC
M4007 Status display for M05 and spindle stop
PLC PLC
M4008 Disable speed output for spindle
PLC PLC
M4009
PLC
Spindle rotation counterclockwise (for gear change)
PLC
M4010 Spindle rotation clockwise (for gear change)
PLC PLC
M4011 Activate rotational speed MP3520.0 and direction of rotation from
M4013
PLC PLC
M4012 Open the spindle control loop
PLC PLC
M4013 Direction for spindle orientation
0 = M03
1 = M04
PLC PLC
M4014 Reverse the direction of spindle rotation
PLC PLC
M4015 Renewed evaluation of the spindle reference mark
PLC NC
M4016 Cycle 13 is executed
NC
PLC
M4017 Controlled spindle in motion
NC
NC
M4018 Reference mark for spindle not yet traversed
NC
NC
Thread Cutting
M4030 Cycle 2 or Cycle 17 active
NC
NC
M4031 Cycle 17 or Cycle 18 active
NC
NC
Coolant Status
M4040 Status display M07, M08, M09 highlighted
PLC PLC
M4041 Status display M07, M08, M09 and MK
PLC PLC
M4042 Status display M07, M08, M09 and MK
PLC PLC
Touch Probe
M4050 Touch probe not ready (ready signal is missing)
NC
NC
M4051 Stylus deflected before start of probing cycle NC
NC
M4052 Stylus deflected (probing process not executed)
NC
PLC
M4053 Probing sequence ended or interrupted
NC
NC