HEIDENHAIN TNC 370D - Manual (Page 70)

July 02 Machine Parameters TNC 370 D 4–67
4.10 3-D Touch Probe
Machine
parameter Function and input Change via Reaction
MP6010 Selection of the touch probe
Input:
0 = Touch probe 220
1 = Touch probe 630 CN
PLC
MP6120 Probe feed rate (triggering touch probe)
Input: 10 to 3000 [mm/min] CN
PLC
RUN
MP6130 Maximum measuring range
Input: 0.001 to 30 000.000 [mm] CN
PLC
RUN
MP6140 Setup clearance above measuring point
Input: 0.001 to 30 000.000 [mm] CN
PLC
RUN
MP6150 Rapid traverse in probing cycle (triggering
touch probe)
Input: 80 to 30 000 [mm/min] CN
PLC
RUN
MP6160 M function for 180° turn of the spindle
Input: –1 to 88
–1 = Spindle orientation directly through NC
0 = Function inactive
1 to 88 = Number of the M function for
spindle orientation through the PLC CN
PLC
RUN
MP6210 Number of the oscillations in normal
direction per second
Input: 0 to 65.535 [1/s] CN
PLC
RUN
MP6230 Feed rate in normal direction
Input: 0 to 1000 [mm/min] CN
PLC
RUN
MP6240 Maximum stylus deflection
Input: 0 to 10.000 [mm] CN
PLC
RUN
MP6260 Output of M90 for NC blocks with digitized
data
Input:
0 = no output of M90
1 = output of M90 in each NC block CN
PLC
RUN
MP6270 Rounding decimal places
Input:
0 = output in 0.001-mm steps (1 µm)
1 = output in 0.01-mm steps (10 µm) CN
PLC
RUN