HEIDENHAIN TNC 370D - Manual (Page 76)

July 02 Machine Parameters TNC 370 D 4–73
Machine
parameter Function and input Change via Reaction
MP7270 Feed-rate display in the "Manual operation"
and "Electronic handwheel" modes
Input: %xx
Bit 0 = 0 display of the axis feed rate only
when an axis-direction button is
pressed (axis-specific feed from
MP1020.x)
Bit 0 =1 display of the axis feed-rate even
before operating an axis-direction
button (smallest value from
MP1020.x for all axes)
Bit 1 =1 interruption when NC stop during
manual mode
CN
PLC
RUN
MP7274 Display current gear range
Input: 0 or 1
0 = no display
1 = display
CN
PLC
RUN
MP7280 Decimal sign
Input: 0 = decimal comma
1 = decimal point
CN
PLC
RUN
MP7285 Offset tool length in the position display of
the tool axis
Input:
0 = tool length is not offset
1 = tool length is offset CN
PLC
RUN
MP7290.0-3 Position display step
Input: 0 = 0.1 mm or 0.1°
1 = 0.05 mm or 0.05°
2 = 0.01 mm or 0.01°
3 = 0.005 mm or 0.005°
4 = 0.001 mm or 0.001°
CN
MP7295 Inhibit datum set on axis-specific basis
Input: %00xxxx
0 = do not inhibit datum set
1 = inhibit datum set
Bits 4 and 5 reserved, enter 0
(no DATUM SET soft key,
if datum set inhibited for all axes)