Grass Valley Performer SD - Manual (Page 99)

2-67
Control Panel Reference
RS422, X–Y Mode, Modem Cabling
When connecting the SCP through a modem, the X-Y mode is
used.
1. Cable to your modem as described in the modem
manufacturer’s literature. Use GVG Cable TNX-CTM,
which can be up to 50 ft. (15 meters) in length, specified at
the time of the order. Connect the cable from J232 of the
control panel to the RS232 port of the modem.
2. Set the modem switches to achieve the following:
■ Disable or turn off modem response codes to
terminal, or select the mode which sends them as
numbers.
■ Disable or turn off command character echo.
■ Other settings will vary with particular modem.
At the far end, connect the Performer REMOTE connector to
the modem serial port using GVG Cable TNX-MIC, which can
be up to 50 ft. (15 meters) in length, specified at the time you
order the cable.