Grass Valley Performer SD - Manual (Page 119)

3-1
Operation & Service 3
Introduction
The Performer™ can be operated in a very intuitive manner. The
switcher will select any one of the ten input sources for output on
its single destination. Performer will also allow you to place a
protect, that is, to easily set the switcher so that the current
selection is locked and prevented from accidental change.
This section describes the following:
■ Performer & Performer Remote Panel Operation
■ Joystick Override Operation
■ TEN-XL Control Panels Operation
■ TEN–20, 20–TEN Control Panels Operation
■ TEN–20, 20–TEN Serial Interface Operation
■ Serial Protocol Descriptions
■ Service Information
It is possible to control Performer from a Grass Valley Group
Model 100 or 110, 200, or 300 Production Switcher, or from an
RS232 or RS422-compatible terminal or computer. Control from a
Production Switcher is either invisible to the Production Switcher
operator (providing the Production Switcher is appropriately
equipped and configured), or is described in the pertinent
Production Switcher documentation. Use of RS232 or RS422
control via a terminal or computer is dependent upon
configuration and connection requirements, which are described
in the
Installation section of this guide. The Serial Protocol
Descriptions provide the technical information needed for control
from production switchers and terminals.