Grass Valley Performer SD - Manual (Page 181)

Index-3
Index
destination offset 2-52
level offset 2-53
source offset 2-51
S2 2-10
S3 2-10
self-test 2-8
serial communications protocol selec-
tion
2-45
setup switch location 2-10
SMPTE 3245-E Protocol 3-52
standard features 1-2
status information 2-8
switch location 2-10
switch reference table 2-41
T
Tally Board
2-3
Tally board 1-7
Tally Board option 2-35
Tally Board option installation 2-36
TEN–20 Panel
cabling 2-83
TEN–20 Panel Switch Settings
BPS and MBCP Panels Switch Set-
tings 2-75
levels controlled, level tallied 2-76
TEN–20, 20–TEN BPS Control Panel
to Performer
error indications 3-20
placing protects 3-20
source selection 3-20
TEN–20, 20–TEN MBCP to Performer
clearing entry errors 3-23
displaying destinations 3-24
error codes 3-24
placing protects 3-23
presetting and taking a source 3-23
selecting destinations 3-22
TEN–20/20–TEN Remote Panel Proto-
col, Performer S1 Switch Settings
Destination Offset 2-73
Level Offset 2-74
Source Offset 2-71
TEN–20/20–TEN Serial Interface Pro-
tocol
Enable Protect message 3-40
Release Protect message 3-40
Response Message 3-42
Status Request Message 3-41
take message 3-39
TEN-20/20-TEN Serial Interface to
Performer
3-29
TEN-20/20-TEN XYCP Control Panel
to Performer
performing a take 3-27
presetting destinations 3-25
presetting sources 3-26
using the last function 3-27
using the protect function 3-29
TEN–XL ASCII Protocol 3-43
TEN–XL Audio Follow Video Control
Panels to Perfomer
19 x 1 operation 3-12
audio follow video source selection
3-12
TEN-XL SCP
Cabling 2-64
power cabling 2-68
RS232 to single Performer 2-64
RS422, dual mode 2-65
RS422, X–Y Mode, Modem Ca-