Grass Valley Performer SD - Manual (Page 92)

2-60
Section 2 — Installation
Additionally, Performer(s) must be set to TEN–XL ASCII protocol
(switch S2) and odd parity (switch S3)—refer to TEN-XL SCP (X-
Y mode) to Performer in the Common Configurations section. (Seven
data bits is automatically set at the Performer when TEN-XL
ASCII protocol is selected).
Performer Address
To set Performer address to be controlled by TEN-XL SCP in X-Y
mode:
■ Locate switch S1 on Performer (see Performer Setup
Switch Location in Common Configurations section).
■ Set dip switches on S1 for an address between 0 and 99.
The above protocol divides the address switches into two groups
of four each (1, 2, 3, 4 and 5, 6, 7, 8). Each group assigns, in binary,
an address digit from 0 to 9. Digits larger than nine are invalid.
Thus, the highest valid address is 99. Switches 1 - 4 assign the
second, or least significant digit.
OPEN
1 2 3 4 5 6 7 8
8 4 2 1 8 4 2 1
1st digit:
0 +0 = 0 2nd digit:
1 + 4 = 5 Address = 5
S1