Grass Valley Performer SD - Manual (Page 42)

2-10
Section 2 — Installation
Performer Setup Switch Location
While setting up your Performer, you may need to change the
settings of switches S1, S2, and S3 located within the frame. You
won’t have to remove the top cover to access these switches
because a small “slide” cover is located on the frame’s top cover
directly above the switches. See the illustration below.
OPEN
1 2 3 4 5 6 7 8
OPEN
1 2 3 4 5 6 7 8 OPEN
12
34
5 6 7 8
S2
S3
S1
1. Remove screw from side of "slide" cover.
2. Hold "slide" cover tightly against side of
frame and remove top screw.
3. Slide cover to the left to open.