Grass Valley Performer SD - Manual (Page 100)

2-68
Section 2 — Installation
SCP Power Cabling
The SCP uses an external power supply. The supply is 120V or
240V as specified in your order. The supply cords, both the AC
cord and the DC cord from the supply to the SCP, are six feet long.
The unit comes shipped with a 120V type AC plug
1 . If you order
a 240V supply, you must supply the AC plug end due to the large
variation in styles
2 .
To connect the supply:
1. Plug the DC cord from the supply to the 9-pin male power
connector on the rear of the SCP.
2. Plug the AC cord from the supply into a commercial
power outlet.
See the Operation section of this guide for TEN–XL panel
operating instructions.
1. North American Power Supply Cords:
Supplied with molded grounding plug (NEMA 5-15P) at one end and molded grounding connector IEC
320-C13 at the other end. Conductors are CEE color coded: light blue (neutral), brown (line), and geen/
yellow (ground).
2. International Power Supply Cords:
Supplied with molded grounding connector IEC 320-C13 at one end and stripped conductors (50/5mm)
at the other end. Conductors are CEE color coded: light blue (neutral), brown (line), and geen/yellow
(ground). Other IEC 320 C-13 type power supply cords can be used if they comply with the safety reg-
ulations of the country in which they are installed.