Grass Valley Maestro Master Control v.1.7 User Manual
Page 195
Maestro Channel Branding User Guide
191
7th Step: Effects Configuration
Figure 150. Transition Configuration Table
Wipe Transition Sets
A wipe set may be selected for use in video signal transitions if one or more
wipe transition sets have been defined. The defined sets are displayed in
the drop-down list box under the graphical display area.
Transition Name
Enter a descriptive name in this field that defines the actions performed by
the named transition. In the example highlighted in
, the name
of the first transition is “Aud before Vid.” This transition will switch the
audio from the old source to the new source before beginning the video
transition.
Signal
The transition parameters for video and audio signals are defined sepa-
rately. Video parameters are defined in the upper section of each transition
definition. Audio parameters are defined in the lower section.
Type
A transition type is specified for both video and audio signals. The possible
selections for the video signal are FadeFade, CrossFade and Wipe. The pos-
sible selections for the audio signal are FadeFade and CrossFade. The type
selection enables or disables the entry of other transition parameters.