Grass Valley Kaleido-Modular-X v.7.70 - Manual (Page 49)

45
Kaleido-Modular-X
Quick Start Guide
A layout browser appears on the displays associated with the current room.
3 Select the layout you wish to load from the list of available layouts for this room, and
then click OK.
The selected layout appears on the room displays.
Verifying the Audio Bridge Terminal
To verify that the ABT is functioning normally
• Inspect the ACTIVITY and front panel LEDs on the unit to make sure there are no error
conditions:
The ACTIVITY indicator is located on the right-hand side of the rear panel. This LED
reports the status of the Ethernet connection as indicated in the table below.
Two LEDs are visible on the front panel, one for each power supply. When lit, they both
indicate the same status.
When the ABT is powered up, all three LEDs will be orange until the boot sequence is
terminated. This is a visual indicator that the LEDs are functioning properly.
Verifying the Multiviewer’s IP Addresses and Application Version
Finding the System IP Address
To find your multiviewer’s system IP address
1 Press the Select button on the front edge of a Kaleido-Modular-X output card.
The Status LED on the selected card flashes orange, and the associated control menu
appears on the display of the Densité frame’s local control panel.
2 On the local control panel, press the [–] button repeatedly until NETWORK SETTINGS
appears on the display, and then press the SEL button.
ACTIVITY Indicator on Rear Panel Power-Supply LEDs on Front Panel
Color Status Color Status
Off No link detected Green Normal
Green Normal (good link) Flashing green Normal, rebooting
Orange Activity Orange Warning
Red Hardware fault Flashing orange Warning, rebooting
Flashing red Upgrading firmware Red Hardware fault
Flashing red Upgrading firmware